JB ENTERPRISES 

  <a href="https://plus.google.com/111559954666831646460" rel="publisher">Google+</a>itle

 

INOX for Mining

THE ONLY LUBRICANT IN THE WORLD WITH THE SPECIAL MX3 ANTI-MOISTURE, ANTI-CORROSION FORMULA FOR THE 21ST CENTURY. 

INOX was invented over 20 years ago.  It is used to deal with the corrosion problems that were found in the Australian Salt Mines.  What can INOX do for you?

EARTH MOVING MACHINERYINOX lubricant will penetrate and lubricate rusted and corrosion frozen track & blade bolts & nuts, splines & couplings, exhaust systems, air brake parts, fuel injectors, door hinges & locks, bushes & bearings, etc. With HEAT SEIZURES on larger diesel engines (D series/equivalent upwards), pour half a litre of INOX lubricant down each fuel injector port and leave for approximatly 12 hours. In most instances this will free up pistons& rings and allow the engine to recommence operations saving on costly down time and overhauls. INOX can used to a maximum of 3 times for this application before the engine requires a full overhaul. INOX will keep electric starter motors, alternators/generators, air starters, lights, solenoids, switches, circuits, pneumatic systems and other electrical parts and fittings lubricated, corrosion and moisture free. INOX will not harm or effect hydraulic parts, fittings or systems.

SALT MINING: INOX is very effective as an anti-corrosion lubricant for electrical parts , ancf fittings on plant & machinery used in the salt mining and processing industry. INOX (non aerosol) can be sprayed directly into starter motors and alternators/generators for lubrication and protection from corrosion.

WINCHES, CABLES, SHACKLES, SPLINES & COUPLINGS: INOX will keep these lubricated, easy to do up, undo & strip for overhauls and free from corrosion & moisture.

UNDER GROUND PUMP MOTORS & ELECTRICAL SYSTEMS: INOX will keep this equipment free from moisture & corrosion. Should any pump motors, electrical parts or fittings go under water(under ground mine or above ground flood) the equipment or fitting should be flushed with fresh water and a liberal coat of INOX should sprayed inside and out, then allowed to drain for a couple of hours. This will remove any residual moisture and stop corrosion from starting and in the greater majority of cases allow the equipment to go back into immediate service thus saving on costly repairs. INOX can be readily used on all DC, single and multi-phase alternating currents.

AGGREGATE GRADING AND CONVEYOR SYSTEMS: Anywhere there is a high moisture or dust problem around machinery. Use INOX to flush bushes & bearings, sprockets & chains and couplings clean, lubricate and keep corrosion free.  INOX has a self cleaning action and can be used over and over without first cleaning it off. INOX is non-static.

INOX LUBRICANT HAS A WIDE AND WELL ROUNDED APPLICATION FOR THE ONGOING MAINTENANCE AND SMOOTHER OPERATION OF ALL TYPES OF MACHINERY, PLANT AND EQUIPMENT USED FOR THE FARMING, MINING AND EARTH MOVING INDUSTRY.

INOX® QUALITY PRODUCTS

"There is no substitute for quality"

7<>  _ Cav fi-J  7 "