Diesel Medic
MATERIAL SAFETY DATA SHEET
Fuel Medics.com
3777 ne 163m street #148
North Miami Beach Florida 33160
(800) 951-5430
May be used to comply with OSHA's Hazard Communication Standard 29CFR 1910.1200. Standard must be consulted for specific requirements.
SECTION I IDENTIFICATION
Trade Name: Diesel Medic/Diesel Cleaner
Product Code: 10100Dm
U.S. D.O.T. Shipping Name: Combustible liquid, n.o.s.
Technical Name: N/A
U.S. D.O.T. Primary Hazard Class: N/A
U.S. D.O.T. Secondary Hazard Class: N/A
Identification Number: NA1993
IATA (Airline): Not Regulated
Maritime: Not Regulated
Packing Group: lll
SECTION II HAZARDOUS INGREDIENTS - IDENTITY INFORMATION
Hazardous Components: CAS# OSHA PEL ACGIH TLV
Heavy aromatic naptha 64742-94-5 100 ppm 100 ppm
Trimethylbenzene* 95-63-6 25 ppm 25 ppm
*reportable under SARA 313 - 18% by weight
Xylene** 1330-20-7 100 ppm 100 ppm
**reportable under SARA 313 - 18% by weight
Cumene*** 98-82-8 50 ppm 50 ppm
***reportable under SARA 313 - 18% by weight
Ethylhexylnrtrate 27247-96-7 N/A N/A
Ethylene glycol monobutyl ether**** 111-76-2 100 ppm 100 ppm
****reportable under SARA 313 - 15% by weight
Other components, if any, are considered to be non-hazardous as per OSHA 29 CFR 1910.1200.
SECTION III PHYSICAL & CHEMICAL CHARACTERISTICS
FLASH POINT: 145°F ASTM D56 Tag Closed Cup
BOILING POINT: 235-240°F
SPECIFIC GRAVITY (H20 = 1): 0.90 @ 25°C
VAPOR DENSITY (AIR = 1): Greater
EVAPORATION RATE (BA = 1): Slower
% SOLIDS: Negligible
WEIGHT (LB./GAL.): 7.51
SOLUBILITY IN WATER: Slight
VISCOSITY @ 25C: 4.8 - 6.8 cps
APPEARANCE & ODOR: Amber liquid, sweet odor
SECTION IV FIRE & EXPLOSION HAZARD DATA
EXTINGUISHING MEDIA: Dry chemical foam or water fog.
SPECIAL FIRE FIGHTING PROCEDURES: Protect against decomposition products. Wear Self Contained Breathing Apparatus.
UNUSUAL FIRE & EXPLOSION HAZARDS: Heating of non-vented container may cause explosion. Keep surrounding containers cool with water spray.
SECTION V REACTIVITY DATA
STABILITY: Stable.
CONDTIONS TO AVOID: Contact with open flame.
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon Monoxide and unidentified organic compounds may be formed during combustion
HAZARDOUS POLYMERIZATION: Will not occur.
SECTION VI HEALTH HAZARD DATA
SIGNS AND SYMPTOMS OF EXPOSURE:
EYES: Irritation, redness
DERMAL: Dryness. Irritation, redness
INHALATION: Vapors may irritate nose, throat, and respiratory tract.
INGESTION: Nausea, vomiting, dizziness, headache, blurred vision.
EMERGENCY AND FIRST AID PROCEDURES:
EYES: Flush with large amounts of water for 15 minutes.
DERMAL: Wash with soap and water.
INHALATION: Remove victim to fresh air.
INGESTION: Do not induce vomiting. Get medical attention.
ACUTE HEALTH HAZARDS: Irritation of skin and eyes.
CHRONIC HEALTH HAZARDS: Observations in animals include blood, kidney and reproductive effects.
SECTION VII SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Dike area. Remove all sources of ignition. Ventilate area if necessary. Absorb free liquid with earth, sand, clay, or absorbent pads and place in non-leak containers for disposal. Flush area for trace residue and dispose of as below.
WASTE DISPOSAL METHOD: In accordance with Federal, State, and Local Laws.
SECTION VIII SPECIAL PROTECTION INFORMATION
RESPIRATORY PROTECTION: Normally not needed in a well ventilated area.
VENTILATION: Mechanical to maintain good air flow.
PROTECTIVE GLOVES: Rubber.
EYE PROTECTION: Goggles or safety glasses.
OTHER: As needed to minimize exposure.
HYGENIC PRACTICES: Always wash face and hands after contact.
SECTION IX NOTES
The information contained herein is based on data considered accurate. However, no warranty is expressed or implied regarding the accuracy of this data or results to be obtained from the use thereof. Vendor assumes no responsibility for injury to vendee or third person proximately caused by the material if reasonable safety procedures are not adhered to as stipulated in the data sheet.
Additionally, vendor assumes no responsibility for injury to vendee or third persons proximately caused by abnormal use of the material even if reasonable safety procedures are followed. Furthermore, vendee assumes the risk in the use of this material.
Revision date: January 7, 2007